Version Notes 

OPTALIGN PLUS 2.05

• Sensor update for sector issues.
• Instructions: Extract files and run OPTAPLUP.EXE.

OPTALIGN PLUS 2.03

• Fix for the OPTALIGN PLUS direct print ASCII file line-shift bug for the position of the thermal growth values.

OPTALIGN PLUS 2.00

• OPTALIGN PLUS SERIES compatibility
• Use with OPTALIGN PLUS Explorer PC software v2.2x

IMPORTANT: Firmware version 2.x IS NOT supported by the Optalign PLUS Commander PC software.

OPTALIGN PLUS 1.24

• Report layout improved: 
  Additional comment line. 
  Added page numbering in both report types (text and graphical).

• Changing F-82 Averaging during a set of Multipoint or Static readings takes effect immediately.

• Improved averaging, range restricted to 2...7 (equals an average number of 4 to 128)

• Minor changes regarding F-84 setting (High/Low resolution)

• Inch mode Coupling results print in high resolution independent of F-84 setting. In Move Move values are displayed as per F-84 setting.
  Correction results in printed report are printed according to the F-84 setting.

• In graphical report, the left side soft foot values are now printed.

• In graphical report, the dimensions to the left machine are printed in report if needed (static feet settings or left machine has values for thermal growth).

IMPORTANT: This firmware version IS supported by the Optalign PLUS Commander PC software. This FW version is only available upon request.

Depending on the feature level of your tool, not every feature described on these forms may be available to you.

For FW 1.20 or higher

01-597-01 OPTALIGN PLUS Quick Reference
F74 Default: Foot Results
plusqckref122foot.pdf

Go to Alignment Reporter